Circulative and Sustainable
Waste treatment

Our Technology

Let's Maximize
Waste Energy

with Our Pyrolysis - Circulative Waste Treatment System - GOMIX

Our Functional Uniquness

Don't Burn waste "Pyrolize"

GOMIX does not incinerate waste. It is pyrolyzed. Since waste is not burned, no CO2 emissions or toxic substances such as dioxin are generated. The gases generated are utilized for the operation with no environmental impact.

Our Pyrolysis technology makes renewable energy from waste.

“Waste is the new resource”

Recovery Resources from Waste

GOMIX recovers resources from waste. The recovered resources vary depending on the input materials. Plastics and resins can be recycled into recycled oil, organic materials into charcoal, and metals can be recovered as they are. These resources
can be reused, and waste can be utilized as new energy.  In addition, when plastic waste is targeted, the energy recovered is greater than the energy input, making it possible to store resources while processing waste.

Mixed-Waste Acceptable

Waste from all over the world is in a mixed state and is very difficult to sort; GOMIX can process it without sorting or washing. This is a great uniqueness for waste disposal.

“No Segregation, Just Throw in”

Our Models

We have several models to adopt necessary size for clients.

Model : GXC-100, GXC-40,GXB-10, GXB-5,GXB-1

 

Our technology has a scalable features. For example, we can expand the furnace. It means 1 system control whole waste treatment system and expand the capacity later if it’s needed.  

Our Recovered Resources

Our technology can collect Recovered Oil from Plastic waste, Charcoal from organic waste and metals.

Pyrolysis Mechanism

Pyrolysis Mechanism is s follows:

 

1.Steam is used to drive out oxygen in the reactor to create an oxygen-free condition.

2. Distillate and vaporize waste in high temperature reactor.

3. The vaporized gas is cooled and the gas and oil are recovered at ambient temperature

4. The input waste is greatly reduced in volume, and the organic matter is carbonized and recovered as charcoal.

We have an ROI calculation sheet for our customers. If the extracted oil is used as fuel, a cost-benefit comparison with the fuel that was originally intended to be used and a comparison of carbon dioxide emissions with the waste combustion are also calculated at the same time.

Our machine doesn’t need lots of operators for the operation because our machine runs automatically once the operator starts.

Operator needs to input the waste and confirm the output only. 2 or 3 people for 1 machine is enough to operate.

For daily operation, Cleaning the catalysis component is very important. It’s very easy to replace the catalysis because the catalysis component is cartridge. and, catalysis can be washed and re-used again. It takes only few minutes.

For annual maintenance, it will take 1 or 2 days per 3 months. We’ll check every component status and clean up whole system.

Our machine needs water and electricity or diesel for the operation. 

In case of water quality is bad, we need to install the water treatment equipment to input the water into our machine. It needs chemical material and salt. If the quality of water is good, the water treatment equipment is NOT necessary.

For batch type, Sealing is sometimes needed to be replaced. 

Catalysis can be washed and reusable. so, if it’s not broken, no need to purchase additional.

It is categorized into chemical recycling and thermal recycling.

As soon as we receive the deposit from the customer, we start manufacturing. It takes about 2 months for a small model and up to 6 months for a large model. After that, we will carry out the transportation procedures to the site and bring in the product. Assembly at the site takes about one week

Our equipment requires water and electricity, so the respective supply work is necessary.
(Electricity supply can be substituted with a generator.)
Even the smallest model weighs about 10 tons at total.
It requires concrete or other foundation work and a level ground. The equipment can also be installed outdoors, but in that case, a roof should be installed.
The equipment itself requires only a small area of land, but it is necessary to secure a separate space for storing waste stacks.

No odor or noise is generated due to the specifications of GOMIX, which treats waste with superheated steam instead of burning it and has no moving parts.

In case of failure, we will repair it at our expense for 1 year.
Warranty period up to 3 years.

Our Catalogue

If you’re interested in our technology, we can provide our catalogue and business summary to you. Please get contact with us!

Contact

GOMI Solutions Co.,Ltd.

3-8-1 Asia-pacific Import Mart 6F, 

Asano, Kitakyushu Kokurakita-ku, 

Fukuoka, JAPAN.

Zip:802-0001 

GOMI Solutions Co.,Ltd. © All Rights Reserved.